Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may find that your garage door opener has actually been giving you issues, so you need to repair it. You can repair it by changing a motherboard, a photo-eye sensor, the primary drive gear, or the set-limit switches. You can also check if the safety and security sensing units are working effectively.

Replacing a motherboard

Replacing a circuit board for your garage door opener calls for a few steps and devices. Initially, you need to turn off the circuit breaker and detach any cables. Next, open the motherboard cover. This will assist you to detect the issue and identify if you need a brand-new board. Next, get rid of the old board and its cord connectors.

You can then continue to replace the circuit card. The substitute procedure is simple and also takes about 10 minutes. A brand-new circuit card will cost regarding $80. To protect your new circuit board from power rises, you can buy a surge guard.

Replacing a photo-eye sensor

Changing a photo-eye sensor can be a fairly easy job. Initially, eliminate the sensing unit from the door as well as ensure it is located correctly. If the sensing unit is angled in any way, it may not be getting the appropriate signal, which can be causing the blinking lights. If you see that the photo-eyes are out of alignment, you may need to have a technician come and also fix the trouble.

The photo-eye sensing unit consists of two items that place on the outside of the door tracks as well as towards the floor. The photo eyes will have a small LED light and should be strong in shade. If the light is blinking, its most likely the photo-eye is defective and will need to be changed.

Replacing a primary drive equipment

To replace a garage door opener primary drive equipment, begin by removing the cap from the chain pulley-block. Next off, get rid of both screws holding the drive equipment to the gear assembly. Now, you can loosen the 3 stress pins. Press them from both sides and after that eliminate them. Then, separate the three cables from the garage door opener electric motor. These wires must be white, red, as well as blue.

Once you have actually removed the old equipment, mount a new one. Make sure to oil it well. Put the brand-new gear into the shaft, making sure to align the installing holes. Make certain the gear and also gear setting up are positioned properly to make certain smooth procedure. Next, utilize a hammer as well as a nail to drive a pin right into the new gear.

Adjusting the set-limit buttons

The very first point you should do if your garage door is not working properly is to examine the set-limit buttons. You may require to change them so that the door closes earlier or quits before it reaches the floor. You can inspect this by considering your garage doors manual or online.

To change the set-limit switches, youll need a screwdriver or socket. Change the knob clockwise or counterclockwise until the door moves up and also quits, or decreases its distance. To check for proper traveling distance, determine the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *